SEN0213

Analogue ECG sensor for use with Arduino projects; used to measure the electrical activity of the heart and monitor heart rate. This electrical activity can be charted and output as an analogue reading. An ECG signal can be extremely noisy so an AD8232 chip is included which will generate a clear signal from the PR and QT Intervals. By using the Arduino IDE Serial Plotter feature you will be able to view the plotted ECG output on a PC.

• Input Voltage: 3.3 to 6V (5V recommended)
• 0 to 3.3V Output voltage
• Analogue interface
• Plug and play 3-pin Gravity interface

内容

ECG sensor board, ECG sensor cable, 6x Biomedical sensor pads and Gravity cable

注意事項

Note: This is NOT a medical device and is not intended to be used to diagnose or treat any condition