103030215

CAN-BUS shield V2 adopts MCP2515 and MCP2551 for controller and transceiver, it is compatible with Arduino which means it can switch an Arduino board like Arduino Uno to start your CAN-BUS project.

• Implements CAN V2.0B at up to 1 Mb/s
• Industrial standard 9 pin sub-D connector
• OBD-II and CAN standard pinout selectable
• Changeable chip select pin, changeable CS pin for TF card slot, changeable INT pin
• Screw terminal that easily to connect CAN_H and CAN_L
• Arduino uno pin headers
• Micro SD card holder
• 2 grove connectors (I2C and UART), SPI interface up to 10MHz
• Standard (11 bit) and extended (29 bit) data and remote frames
• Two receive buffers with prioritized message storage